Farenhyt IDP-PHOTO-R-W Plug-In Smoke SensorWhen used in duct applications with a DNR(W), testing can be done remotely using approved System Sensor test accessories, eliminating the need for a test coil. The sensors transmit an analog representation of smoke density over a communication line to a control panel. Rotary dial switches are provided for setting the sensors address.

4-inch square

Minimum hardware required is: one (1) air-duct housing assembly

200° F (93° C) fixed temperature detector are for normal temperatures that exceed 100° F (38° C) but are less than 150° F (66° C)

Built to operate under demanding conditions

— Connections for Remote LED Alarm Indicator or Unsupervised Relay

a sensitivity test can be performed at any time from the safety and comfort of a maintenance office or utility room

monitor modules

Riser Monitor Modules may be used to monitor telephone risers or 70 Vac audio

— 2099-9804 Replacement break-rod

Completely configurable via onboard DIP switches

Notifier 90244-L8 Hinge Kit

The standard sampling points allow blind mounting removing any need to access the ceiling void once the microbore tubes are installed and passed through the ceiling